Catler JE 4010 - Manual (Page 10)

OPERATING YOUR JE 4010 JUICE EXTRACTOR
Step 1
Wash selection of fruit and vegetables to be
juiced.
Most fruit and vegetables such as apples,
carrots and cucumbers will not need to be
cut or trimmed to size as these will fi t whole
into the feed chute. Ensure vegetables such as
beetroot, carrots, etc. have all soil removed,
are well washed and trimmed of leaves before
juicing.
NOTE
Step 2
Ensure the JE 4010 Juice Extractor is correctly
assembled. Refer to Assembling your JE 4010
Juice Extractor (page 6). Ensure the juice
jug (or a glass) is placed under the spout
and the pulp container is in position before
commencing juicing.
Step 3
Plug the power cord into a 230/240 V power
outlet. Turn the power on at the power
outlet. The LCD display will illuminate.
The LCD display will illuminate continuously
for 3 minutes before going into a sleep mode,
where it will switch off automatically to
conserve power.
The screen will come back on after activating
the ‘On/Off ’ switch, the speed control dial, or
the safety locking arm.
When the safety locking arm is not locked into
place on top of the juicer cover, the LCD display
will illuminate and fl ash with an “L”, indicating
that the safety locking arm should be locked
into place.
When the safety locking arm is locked into
place on top of the juicer cover, the LCD display
will illuminate and display the selected speed
setting. The speed can be changed by adjusting
the variable speed control dial. For a quick
juicing speed reference, use the speed guide
displayed on the LCD screen, the speed selector
table located on the pulp container, or refer to
the speed selector table (page 9).
Hard fruits and vegetables will put excess strain
onto the motor if a low speed is selected. Please
refer to the speed selector table to determine
the correct speed for the fruits and vegetables
being juiced.
NOTE
8
OPERATING YOUR JE 4010 JUICE EXTRACTOR