CASO Germany FastVac 3000 - Manual (Page 43)

caso FastVac 3000 43
 Cleaning bags for reuse
•
Wash the bags in warm water with a mild dishwashing soap, then rinse them well and
allow them to dry completely before reusing
.
DANGER
► Bags used to store raw meats, fish or greasy foods should never be reused due to risk
of contamination.
18 Troubleshooting
The following table may help you narrow down and address minor malfunctions:
18.1 Safety notices
DANGER
► Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
18.2 Troubleshooting table
Fault Possible Cause To Rectify
Device does not turn on Defective power cord Send device to Customer Service
A complete vacuum is
not being created in the
bag.
The open end of the bag is not
completely inside the vacuum
chamber
Position the bag correctly
The bag is defective Select another bag
There is residue on the welding
and the seal Clean the welding / seals and retry
once they are dry
The bag is not being
sealed correctly
The sealing bar is overheating
so that the bag melts
Open the cover on the unit and let it
cool down for a few minutes. Please
use only specified bags and rolls
Carefully follow all the steps in
Chapter “Vacuum with a bag of the
bag roll”.
Roll / bag is not positioned
correctly.
The bag does not hold
the vacuum after it has
been sealed
The bag is defective
Select another bag; wrap paper
around any sharp edges within the
bag.