CASO Germany EMCG 34 PRO - Manual (Page 81)

caso EMCG 34 PRO 81
15.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
15.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the
cause of the fault.
Error code Description
E-1 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking chamber
temperature of 230°C .
Press the Pause/Cancel button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E-3 Sensor fault
The device has detected an error on a sensor and has terminated the current
programme. Press the Pause/Cancel button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.
15.3 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error Possible cause Action
The selected program will not
start.
Device door is not closed Close device door
Power plug is not plugged in Plug in mains plug!
Fuse is not activated Activate fuse
The turntable turns jerkily.
Dirt between the turntable
and the base of cooking
camber
Remove dirt
Dirt on rolling ring
Cooking vessel too large Use different cooking vessel
Food is not sufficiently
defrosted, warmed up or
cooked after preset time has
elapsed.
Incorrectly selected time or
power level Re-set time and power level
Repeat process