Salter Brecknell CS-250 - Manual (Page 8)

CS-250 Series Chair Scales Service Manual
- 7 -
Installation
RS-232 Connecter
USB Connecter
Load cell Connecter
Adaptor Jack

Place the scale on a table.

Connect the adaptor pin in to the scale adaptor jack. Adaptor jack is
locating, rear side of the scale.

Adaptor connects into your AC power socket.
Pluggable equipment must be installed near
an easily accessible socket outlet with a
protective ground/ earth contact.

Turn on the On/Off key. If you want to turn off,
press the key again.

Display will be show the version number and will be starting self checking.

After self checking, display will be come to normal weighing mode.

Warm-up time of 15 minutes stabilizes the measured values after
switching on.

Calibrate with exact calibration weights, minimum 1/3 of the scale capacity
want to use for calibration. For calibration see details in parameter.
Then you can start your operation