beautypg.com

Installation – Salter Brecknell CS-250 User Manual

Page 7

background image

CS-250 Series Chair Scales Service Manual

- 6 -

4. INSTALLATION


Unpacking

Carefully take the balance out of its package, make it sure its not damaged and
all accessories are included.

Remove the weighing scale from the carton.

Remove the protective covering. Store the packaging and to use if you

need to transport the scale later.

Inspect the scale and terminal for damage.

Make sure all components are included

Accessories,

1. Balance
2. Adaptor
3. Product manual


Level Adjusting

Place the scale on a table.

Check the water mark. If, bubble is not centre
adjust the leveling feet until reach centre. Check
the level when you change the location.

Charging Battery

To charge the battery insert the adaptor pin to jack, jack is locating rear side

of the scale. Adaptor simply plug into the mains power. The scale no
needs to be turned on.

The battery should be charged for 12 hours for full capacity.

In the display there is an indicator show the status of battery charging.

When the scale is plugged into the mains power the internal battery will be
recharged. If the indicator off, the battery has a full charge. If it is on, the
battery is nearly discharged and if yellow, the battery is being charged.

Do not use any other type of power adaptor than the one supplied with the

scale.

Verify that the AC power socket outlet is properly protected.


Note: Please charge the battery before using the scale for the first time