Salter Brecknell 400ES - Manual (Page 16)

Page 5 - 2
Newer units only
NAME/CODE DESCRIPTION CODE/VALUE
A10
Handshaking
Enable Enables hardware handshaking for Print Ticket Mode. Valid only
when A6 is set to “1”.
"0" = Disable Handshaking
"1" = Enable Handshaking
0

1
A11
Print Header Tells MP-20 printer to print the header information. Valid only when
A6 is set to “1”.
"0" = Do NOT Print Header
"1" = Print Header
0

1
5.2 USER MENU PROCEDURES
This section provides instructions for all of the User Menu procedures.
5.2.1 ID Number Entry (A8)
1. While in the User Menu mode, scroll to "A 8", then scroll down once using
the #2 key to enter the ID Number menu.
2. The display will momentarily show "ET ID", followed by the current ID
number value.
3. Use the front panel numeric keys to key-in the actual ID number value. If
you make a mistake, press the ZERO key to clear your entry and start over.
4. After setting the exact value, press the NET/GROSS key to save the ID
Number value. The display will show "E ID" momentarily, then revert back
up to A8.
5.2.2 LF (Line Feeds) Number Entry (A9)
1. While in the User Menu mode, scroll to "A 9", then scroll down once using
the #2 key to enter the Line Feeds menu.
2. The display will momentarily show "ET LF", followed by the current line
feeds value.
3. Use the front panel numeric keys to key-in the actual ID number value. If
you make a mistake, press the ZERO key to clear your entry and start over.
4. After setting the exact value, press the NET/GROSS key to save the line
feeds value. The display will show "E LF" momentarily, then revert back up
to A9.