Salter Brecknell 200ES - Manual (Page 36)

8-1
CHAPTER 8: LEGAL FOR TRADE SEALING
8.1 ABS
ENCLOSURE
Indicators in the ABS enclosure can be sealed for commercial (Legal for Trade) applications as
follows.
1. Power off the indicator.
2. On the back of the indicator, locate the setup/calibration switch cover (see illustrations
below).
3. Thread a wire security seal through both drilled head screws securing the calibration
switch cover as well as the single drilled head screw holding on the rear panel.
Power Switch
DC Jack RS 232
Port
LOAD CELL
Setup/Calibration
Switch
Figure 8-1: 200 and 200E ABS Rear Panel
DC Jack Serial Port
LOAD CELL
Setup/Calibration Switch
Port
Figure 8-1a: 200BW ABS Rear Panel
8.2
STAINLESS STEEL ENCLOSURE
Indicators in the stainless steel enclosure can be sealed for commercial (Legal for Trade)
applications as follows.
1. Power off the indicator.
2. On the rear cover of the indicator, locate the calibration switch cover.
3. Thread a wire security seal through both drilled head screws securing the calibration switch cover
as well as the two drilled head screws holding on the rear panel.
Older units
1. Power off the indicator.
2. Locate the two adjacent drilled head screws securing the rear cover.
3. Thread a wire security seal through two drilled head screws securing the rear cover.