Salter Brecknell APD-100 - Manual (Page 19)

APD-100 Automatic Powder Dispenser User Instructions 19
4.4 Load Memory
4.3.1 Auto Repeat Dispensing Mode
The Auto Repeat function repeatedly drops the same charge weight.
1. Press the AUTO REPEAT key once…
The AUTO LED light to the left of the display turns on. This light reminds
you that you are in the auto repeat mode. With the auto repeat mode on,
the APD-100 drops the desired charge weight and auto repeats after the
dispensing cycle is finished.
2. After the APD-100 dispenses the selected charge…
The scale beeps, the display shows AUT. xxx (xxx is the number of
times the weight has been dispensed), then shows the charge weight.
3. Remove and empty the scoop and return it to the scale, the scale will zero out
the scoop and automatically begin to dispense the same load again. If the
scoop is not fully emptied, the scale will show Error2. The scoop must be
emptied fully and returned to the scale platform before the scale will drop
another load.
4. Press the STOP, ZERO/EXIT or the AUTO REPEAT key to exit the auto repeat
function…
This will exit the auto repeat mode and the AUTO LED light will turn off.
4.3.2 Manual Fast /Slow Dispense Mode
1. To manually dispense a charge, press and hold the FAST key. The dispenser
will run the feed tube at a high speed until the key is released.
2. Press and hold the TRICKLE key to run the dispenser at low speed. The feed
tube will turn slowly until the key is released.
4.3.3 Auto Trickle Mode
You can speed up the dispensing process by adding powder to the powder scoop and
then bring it up to the selected weight by pressing the ENTER key. By using a powder
measure to add almost all the powder to the powder scoop and using the dispenser to
automatically finish trickling to the exact weight, the dispensing time is decreased
considerably.
4.4 Load Memory
The APD-100 will store up to 128 of your favorite loads in memory. Each load in
memory has four input lines:
Cartridge Name: C=_ _ _ _
Powder Name: P=_ _ _ _
In dispensing mode, if no powder drops into scoop in a period, APD-100 will show
“Error3”.