AVer EB3004 NET & NET+ - Manual (Page 65)

59
- Max. FPS
Display the maximum frame rate of recording that user has set. Maximum fps total value
depends on the RESOLUTION that user has chosen.
- FPS
Set the number of frames per second to be recorded. The higher the frame rate, it uses more
hard disk space.
- Quality
Select the video quality setting from BEST, HIGH, GOOD, MEDIUM, NORMAL or LOW.
Choosing higher quality allows user to record less hours but the quality of the recorded video is
better.
- FPS(alarm)
Set the number of frames per second to be recorded when alarm has occurred. The higher the
frame rate, it uses more hard disk space.
- QUALITY(alarm)
Select the video quality (BEST, HIGH, GOOD, MEDIUM, NORMAL or LOW) of alarm recording.
Choosing higher quality allows user to record less hours but the quality of the recorded video is
better.
(3) Record Schedule
By default, in 24 hours, the recording schedule is set to always record every hour. Refer to the table
below to customize the recoding condition.
Condition Description
NO RECORD Not recording at all
ALWAYS RECORD Non-stop recording
ALARM RECORD
Start recording when the alarm is activated. The alarm activates status according to the
setting in ALARM SETTING.
SMART RECORD
Automatically switch to record at the frame rate of FPS (alarm) that is setup in CAMERA
CHANNEL SETTING once an alarm is detected and if there is no motion, it records at the
frame rate of FPS that is setup in CAMERA CHANNEL SETTING.
VARIED RECORD
When each channel has different record schedule, the record schedule table will display in
Green color that is indicated as VARIED RECORD.
Select the channel to setup record schedule. Click the type of schedule and select hour (00~23) and
day (Mon ~ Sun), and then, click OK to complete the schedule setting.