AVer EB3004 NET & NET+ - Manual (Page 37)

31
OSD MENU Description
EVENT SETUP
ALARM SETTING
SENSOR SETTING
MOTION DETECTION
ALARM SETTING
Configure parameters of alarm.
ALARM CONTINUOUSLY
ALARM PERIOD
ALARM TYPE
SELECT / DESELECT ALL
SENSOR
RECORD
MOTION DETECTION
VIDEO LOSS
REMOTE TRIGGER
HDD FAIL
005 SEC
ALARM SETUP
1 2 3 4
ALARM TYPE
Select the way of alarming – RECORD, EMAIL, RELAY, or CMS.
ALARM PERIOD
Set the amount of time (in seconds; 0~ 999) for stop alarm action after
alarm has been reset.
ALARM CONTINUOUSLY
Enable/disable to execute the alarm action (ALARM TYPE) continuously
when alarm has been trigger. The alarm action is according to the setting of
ALARM TYPE that user has setup.
i - When ALARM CONTINUOUSLY has been started, it won ‟t be
stop until the recording has been stop manually.
- If ALARM CONTINUOUSLY has been enabled, the ALARM
PERIOD won
‟t be able to configure.
SELECT/DESECLECT ALL
To enable/disable all below selections.
SENSOR
Enable/disable to send out the alarm when sensor has been triggered.
MOTION DETECTION
Enable/disable to send out the alarm when motion has been detected.
i
To activate the motion recording, please enable the Motion
Detection feature here and setup record mode as ALARM RECORD
in
RECORD SCHEDULE .
VIDEO LOSS
Select the channel that will send out the alarm when video is lost.
REMOTE TIRGGER
Allow user to trigger alarm from remote site.
HDD FAIL
Enable/disable to send out alarm when hard disk is failed.