Arc Machines 227 - Manual (Page 63)

MODEL 227
OPERATION MANUAL
Doc # 740063 Rev E
SECTION V - OPERATION
5.13 PRINTER OPERATION
3. (continued)
3. INDIVIDUAL WELD SCHEDULE - When a weld schedule has been
selected from memory a complete copy of all of the function values can be
printed by pressing the PRINT key. This can be done at any portion of the
weld schedule is being displayed except during an ACTUAL WELD
SEQUENCE.
A statement at the bottom of the print out will show whether ALL
PARAMETERS PERFORMED AS PROGRAMMED the last key is
pressed after each weld is made, a hard copy record of performance can be
kept. The DATE is also included on each print out.
4. An Auto-print function can also be set up to have the system automatically
make a print out after each Weld Sequence (in Weld Mode). If this mode
is selected the printer will automatically print out a copy of the complete
weld pass after the weld sequence.
5. There is another print function contained on the Set-Up Screen. This
function is to print a copy of the LIBRARY in the memory of the Optional
M227-EMM unit. Access the Set-Up screens for this operation.
5.19