Canon E 430 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

18
Inserting New Lithium Battery
The CR2025 type lithium battery provides your
camera with enough power to store the date
and time and a character title, even when the
camera is turned off.
One lithium battery will last approximately one
year. (Life span of lithium battery varies slightly
according to ambient conditions.) When the
lithium battery is not in place or is nearly
exhausted, “DATE” flashes in viewfinder,
indicating that the lithium battery needs to be
replaced, ■
bri
Be sure to connect a power source to the
camera before changing the lithium battery,
otherwise, the date and time and character title
will be cleared from camera’s memory and will
have to be reset.
Inserting Procedure Ifga
1. Press GRIP UNLOCK button and
rotate the grip downward.
2. Hold the camera with the battery
pack facing down, then draw out
the iithium battery hoider.
• If the camera is held with the battery pack
facing up, the lithium battery will drop out
when the lithium battery holder is removed.
3. Insert a new lithium battery into
the iithium battery hoider with +
side facing up.
4. Snap the iithium battery hoider
into the compartment.
Warning
The battery used in this device may present a fire or
chemical bum hazard if mistreated. Do not recharge,
disassemble, heat above 100°C or incinerate.
Replace battery with Panasonic CR2025 or Duraceli
DL2025B. Use of another battery may present a risk
of fire or explosion. The used battery should be
handed back to the supplier for safe disposal.
C aution
--------------------------------------------------------
• Make sure + side is facing up in lithium battery
compartment.
• Keep battery out of children’s reach. If swallowed,
contact physician immediately.
•To ensure proper contact, wipe battery with clean,
dry cloth before use.
• Do not pick up battery using tweezers or other
metal tools which may cause short circuiting.
• Do not disassemble, heat or immerse in water, to
avoid risk of explosion.