Top installation and removal – Craftsman 706.596690 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOP INSTALLATION AND REMOVAL
ROLL-AWAYS, CHESTS WITHOUT TASK LIGHT
Tools Required:
Screwdriver, Crosstip
Removal
• Disconnect power from unit.
• For roll-aways, remove work surface,
(See drawer and work surface
installation and removal.
• Remove enough drawers to reach the
top back inside of the unit. (See
Drawer and Work surface installation
and removal.)
• Remove lock retaining clip. Pull lock
out to remove.
• Remove (4) screws holding top in
place.
• For roll-aways, lift top off of unit
enough to access the wiring harness.
Disconnect wiring harness from unit.
• Remove top from unit.
Installation
• For roll-aways, connect the wiring
harness to unit.
• Position top on unit. Attach using (4)
screws.
• Position lock in unit. Install retaining
clip to hold lock in place.
• Make sure the back of the actuator
rod is inserted into the actuator rod
holder in the back of the unit.
• Push the actuator rod toward the back
of unit the and line up with lock. Insert
the actuator rod into the back of the
lock.
• Test lock operation.
• Reinstall drawers.
• Reinstall work surface.
• Reconnect power to the unit.