Craftsman 706.596690 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WIRING HARNESS REPLACEMENT
HARNESS GROMMET REPLACEMENT
Tools Required:
3/8" Wrench
WIRING HARNESS AND HARNESS
GROMMET REMOVAL
• Disconnect power from unit.
• Remove pull out work surface and
enough drawers to reach the top back
inside of the unit. (See drawer and
work surface installation and
removal.)
• Remove lock and top from roll-away.
(See roll-away top removal and
installation.)
• Remove harness grommet from roll-
away.
WIRING HARNESS REMOVAL
• For units with accent lighting under
roll-away, remove bottom drawer and
disconnect accent lighting.
• Remove wiring harness through hole
in roll-away top.
WIRING HARNESS AND HARNESS
GROMMET INSTALLATION
• Insert new wiring harness assembly
into mounting track through hole in top
of roll-away (connector should be on
top.) Slide wiring harness assembly to
bottom of roll-away.
• Install harness grommet over
connector. Insert into hole in top of
roll-away.
• Reinstall top and lock
• If unit has accent lighting, reconnect
accent lighting.
• Test lock operation.
• Reinstall drawers.
• Reconnect power to the unit.
Harness
Grommet