Craftsman 113.225931 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE PROCEEDING.
1. Open motor connector box cover located on left end of
motor (viewed from rear of saw) using a flat blade
screwdriver.
2. Remove GREEN SCREW and lockwasher and insert
screw through round metal terminal on the end of the
GREEN wire of power cord with lockwasher between
terminal and motor frame. (See iilus.)
3. Reinsert GREEN SCREW in the threaded hole. Tighten
securely.
4, insert terminal end of WHITE wire on spade terminal
marked T4 on the motor. Push terminal firmly until
seated.
5. Insert terminal end of BLACK wire on spade terminal
marked T1 on the motor. Push terminal firmly until
seated.
6, Close motor connector box being sure that power cord is
seated in the largest strain relief groove, and tighten box
cover screws.
TERMINAL
29