Finishing curved edges on the abrasive belt – Craftsman 113.225931 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FINISHING CURVED EDGES ON THE
ABRASIVE BELT
CURVED EDGES
Finish outside curves on the abrasive belt and inside
curves on the idier pulley.
FINISHING SMALL END SURFACES AND
CURVED EDGES ON THE ABRASIVE DISC
Move the work across the "Down Side" of the face of
the abrasive disc. For accuracy, use a miter gauge.
NOTE; Use a combination square to square the miter
gauge to the face of the disc, if it is not square, pull out
the index pin, loosen the miter gauge knob and move the
miter gauge slightly until it is square. Without moving
the miter gauge, tighten the knob securely-
Applying the workpiece to the "Up Side” could cause it
to fly up (kickback) which could be hazardous.
The table may be tilted for beveled work.