Craftsman 113.225931 - Manual (Page 14)

assembly
INSTALLING WORK TABLE
NÖTE; Apply cisat bf paste wax to the work table.
This will make it a little easier to feed.the work; ^
1. Loosen the table positioning screw,
2. Iiisert the table support rod in the hole in the base
until the edge of the table is approximately 1/16"
from the abrasive disc. Tighten the screw.
NOTE: There is a second mounting hole in the base. This
is for mounting the table when the belt is used in a ver­
tical position. ;
;
WARNING: To avoid trapping the work or fingers be­
tween the babie and sanding surface, the table edge
shbuid be a maximum 1 /16 inch from the sanding
surface, the table should be completely engaged on
the rod.
INSTALLING ABRASIVE BELT-TENSlONlNG
AND TRACKING
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE REMOV­
ING OR INSTALLING ABRASIVE BELT.
On the smooth side of the abrasive belt you will find a
"directional arrow." The; abrasive beh must run in the
direction of this arrow so that the splice does not coihe
apart. ■; ■
■ ■ ' ■ ■ . ■ ■ ■ ■
1. Loosen the two abrasive belt LOCKING screws.
2. Place the abrasive belt over die pulleys with the direcv
; tional arrow pointing as shown. Make siire the abra­
sive belt is centered on both pulleys.
Turning the abrasive belt ADJUSTING screws will cause
the idler pulley to move in or out. When the idler pulley
is moved outward, it puts TENSION on the belt.
3, Place both of the Vi" wrenches on the ADJUSTING
screws and puli the wrenches toward you. This will
stretch the abrasive belt. Move the wrenches back and
forth a few times so that you "get the fee!" of the
abrasive belt while it is stretching (TENSIONING),
Apply a small amount of TENSION to the abrasive
belt by pulling the wrenches toward you, so that the
TENSION feels the sarhe on both wrenches.
PULL WRENCHES IN THIS
DIRECTION TO APPLY
TENSION
DIRECTIONAL ARROW
BELT ADJUSTING SCREWS
BELT LOCKING SCREW
14