Craftsman 113.225931 - Manual (Page 22)

riMiifeiiarîcé
WARNING: FOR YOUR OWN SAFETY> TURN
SWITCH "OFF'' AND REMOVE PLUG FROW
POWER SOURCE OUTLET BE FORE ADJUST­
ING, MAINTAINING, OR LUBRICATING
YOUR FINISHING MACHiNE.
Keep your machine and your workshop clean. The dust
traps around the abrasive disc and the abrasive belt are
designed to deflect most of the fine dust. They should be
connected to a Vac for most efficient dust removal.
WARNING: DO NOT ATTACH A VACWHEN FINISHING
IRON OR STEEL. THE SPARKS COULD IGNITE THE
DEBRIS AND CAUSE A FIRE.
tf power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Frequently Wow out any dust that may accumulate
inside the motor.
A coat of automobile-type wax applied to the work­
table will make it a little easier to feed the work while
finishing.
Do not apply wax to the abrasive belt table because the
belt could pick up the wax and deposit it on the pulleys,
causing the’belt to slip.
MOTOR MAINTEMAWCE AMD
LUBRICATiOM
1. The bearings, in both end shields of the motor, have been
lubricated at the factory with correct lubricant. No other
part of the motor requires lubrication.
2. Re-lubricate motor bearings in accordance with the
instructions on the nameplate. Be sure to wipe oil dirt or
grit if present around oil hole caps to prevent any possibility
of foreign material contaminating the oil wicks that supply
the bearings with oil. Use a good grade of medium weight
mineral oil. such as automobile engine oil, SAE 20.
3. If disassembly of the motor is necessary, it should be
returned to your nearest Sears retail or mail-order store in
order to prevent voiding the guarantee.
NOTE: The speed of this rnotor cannot be regulated or
changed.
4. Every effort should be made to prevent foreign material
from entering the motor. When operated under conditions
likely to permit accumulations of dust, dirt, or waste within
the motor, a visual inspection should be made at Irequent
intervals. Accumulations of dry dust can usually be blown
out successfully.
NOTE: Motors usedon wood working tools are particularly
susceptible to the accumulation of sawdust and wood chips
and should be blown out or "vacuumed" frequently to
prevent interference with normal motor ventilation and
proper operation of the centrifugaliy-operated starting
switch.
iiibricafiori
The BEARINGS in this machine are packed with grease at
the factory. They require no further lubrication.
Periodically 1 ubricate the cams and shafts in the idler pulley
mechanism with Silicon Spray; ................. ,
SEARS RECOMMENDS THE
FOLLOWING ACCESSORIES
ITEM CAT. NO.
Steel Stand .................................................................9-22213
Caster Set . .. ........................................... 9-22222, 9-22221
Niiter Gauge .............................................................. 9-29929
Pressure-Sensitive cement .......................................... 9-2220
Abrasive Belts and Disc .............................. SEE CATALOG
Steel Legs ................................................................ 9-22236
Power Tool Know How Handbooks
Radial Saw ............................................................. 9-2917
Table Saw ................................................................. 9-2918
Sears may recommend other accessories not listed in the
manual. See your nearest Sears store or catalog department
for other accessories. Do not use any accessory unless you
have received and read complete instructions for its use.
22