Craftsman 113.225931 - Manual (Page 10)

6. Fiind five; 3/Ö'' Pan Head iSelf-Trcàdtng screws from
'W/îamorigitHeddoi^ y :.. ■^ :^;y
7. Place Disc Dust Trap on your workbench and screw in
five Pan Head "Thread Gutting Screws," 3/8" long.
Screw them in all the way.
NOTE: The holes in theTrap are not threaded but the
screws are "Thre^ Cutting Screws" and will cut a
thread as they arc tightened.
DISC DUST TRAP
8. Find four Flat Head Machine Screws 1-%"lohg from
among the loose parts
9; Attach thé Disc Dust Trap with four flat head screws
10. There is a flat spot on the shaft near the end. Rotate
the shaft so that the flat spot is facing up.
FLAT HEAD SCREWS
5/32 INCH
11 . Place the disc on the shaft so that the set screw is
facing up. Position the disc SO that it is approx. 1/16
inch outward from the edge of the dust trap. :
12. Insert the long end of the 5/32" setscrew wrench
through the hole in the disc housing and into the
. setscrew in the disc. Make sure setscrew is aligned
/with "Flat" on shaft. ■ .
NOTE: After several hours of operation, check for
i; ■ y . looseness of setscrew and retighten. .
13: Make certain that the metal disc is free of oil and
grease then peel the backing from the 9" abrasive disc
and affix to the sanding disc,
; y
10