Using, Location on screen, Accessing the display screen – Samsung VR5160 User Manual
Page 21: Record fiie information, Iliisiiisi, Vcr operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
VCR Operation
Using
The display function gives
Location on screen
Upper left comer
Upper center
Upper right
comer
Center
Lower left com«^
Lower
center comer
Lower right
iliiSiiiSi
you information about the status of your VCR.
Display information
The VCR functions (Play, Stop or Record).
Audio Status (VR8160 only)
Channel VCR is tuned to.
Record file (The date, time, crfiarlnd and steiion ID).
Amount of time that has elapsed since
the counter was last reset.
Tape speed (SP and SLP).
Tape remaining graphic.
STOP ((MAIN)) 06
Accessing the DISPLAY screen
1
Press the
DISPLAY
birtton while the cassette is playing or
recording. After approximately 3 secorxls, the display
automatically changes, then only the counter and graphic
displays are shown.
Press the
DISPLAY
button to switch the counter mode to
showing the time remaining on the tape.
Press the
DISPLAY
button again to remove display from
the TV screen.
Note:
In order for display information to be accurate, set up the tape length in the VCR Function Setup first
(page 13).
Record fiie information
The record file is displayed only when playing a tape recorded on this VCR.
When a recorded tape is initially played in the VCR, the record file is displayed after 3 seconds.
If the time and date aren't set, only the recorded channel number will be displayed.
When the VCR mode changes, the display information will be delayed about 10 seconds.
The station ID data is displayed only when available.
17