Craftsman 113.24181 - Manual (Page 8)

SPRING CLIP
Insert forefinger into table-insert slot and pull upward to
remove insert.
Replace insert. If clips do not hold insert securely, remove
insert and bend clips.
CHECKING BLADE SQUARENESS TO TABLE
1
.
2 .
3.
4.
Loosen ELEVATION LOCK by pulling KNOB forward.
Turn ELEVATION crank clockwise until blade is as
high up as it will go.
IMPORTANT: BLADE must be SQUARE (90°) to
TABLE, in order to ALIGN rip fence.
Check for BLADE SQUARENESS ... if blade is not
square to table, adjust it at this time.
Refer to "BLADE TILT, OR SQUARENESS OF
BLADE TO TABLE" adjustmenst on page24.
ATTACHING TABLE EXTENSIONS
the loose parts find the following f.
F rom among
hardware:
8 Hex Head Screws 5/16 in. - 18 x 1-1/4 in. long
8 Lockwashers, 5/16 in. External Type (approx, dia. of
hole 5/16 in.)
8 Hex Nuts, 5/16 in. - 18 (approx, dia. of hole 5/16 in.)
Insert screws through holes in EXTENSION then through
table. Install lockwadters and screw on the nuts . .. DO
NOT TIGHTEN.
Align front edge of extension with front edge of saw table.
Pul! Extension UPWARDS above table surface ...
SLIGHTLY TIGHTEN SCREWS using 1/2 in. wrench.
Using smalt block of hardwood and hammer, tap extension
DOWNWARDS at front, center 8t rear, until it is EVEN
with table surface .. . TIGHTEN SCREWS.