Craftsman 113.24181 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

If blade IS SQUARE to table;

Check pointer

If POINTER DOES NOT point to the "O" mark on the

bevel scale;

Loosen screw and adjust pointer .. . using medium

screwdriver.

If blade is NOT SQUARE to table ... the 90° stop screw

must be ADJUSTED.

1. Unscrew 90° STOP SCREW three or four turns using

3/16 in. setscrew wrench.

2. Tilt blade so that it is square with table.

Screw 90° stop screw IN until it stops ... check once

again for squareness and readjust screw, if necessary.

Check POINTER .. . readjust, if necessary.

Tilt blade to 45° and adjust 45° STOP SCREW the

same way.