Craftsman 113.299780 - Manual (Page 15)

maintenance
A WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF'’ AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE MAINTAINING YOUR
DUST COLLECTION SYSTEM.
A WARNING; TO AVOID INJURY FROM ELEC­
TRIC SHOCK OR SUDDENLY STARTING UNIT, AL­
WAYS REMOVE SWITCH KEY AND KEEP UN­
PLUGGED WHILE UNIT IS DISASSEMBLED IN ANY
WAY. ALWAYS REASSEMBLE WITH RECOM­
MENDED PARTS BEFORE PLUGGING UNIT IN.
CHIP COLLECTING BAG REMOVAL
1. Push Band up and slide opposite edge to the m iddle
opening.
2. Low er Band carefully through opening as show n.
D eposit chips in appropriate m etal container.
A CAUTION: Wear Safety goggles ANSI Z87.1
to protect your eyes prior to commencing opera­
tion.
3. Reconnect the Chip Collecting Bag by sliding the
Band through the hpie and slide the opposite side
under Dust Chute Extension. Seat as shown.
FILTER/DUST BAG REMOVAL
A CAUTION: If using this Dust Collection System
to help keep airborne wood dust In heavy usage
within acceptable limits, you must regularly monitor
air borne dust and maintain Dust Collection System
to avoid exceeding dust limits. Each application Is
unique. Your maintenance schedule must, there­
fore, be tailored to your specific use of this Dust
Collection System.
1. Shake the Filter/Dust Bag so the fine dust fails into
low er Chip Coltecting Bag.
2. D isconnect the Adjustable Band Clamp by releasir^
the Spring Lever Clamp.
3. R em ove the Filter/Dust Bag and deposit all fine dust
in an appropriate m etal container.
4. R econnect the Bag carefully so the Clamp w raps
around the Bag on ail sides. Adjust the lever to the
fourth hook and fasten securely.
5. Slip loop over hook on Filter/Dust Bag Holder.
15