Operation, Accessories to inlet, Connecting dust collection system to power source – Craftsman 113.299780 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

operation

This Dust Collection System is designed to be con

nected directly to the woodworking machines. Please,
use only the parts provided for maximum efficiency.

Diameter x

60"

Hose.

PVC Vulcanized rubber

with wire reinforcement and 2 - 4" clamps.

4*72-1/2"

Diameter Adapter.

This connector allows

direct

hookup

m any

m achines

including

Bandsaws, Belt and Disk Sanders, and Radial

Saw Saw dust C ollector.

WARNING: To avoid fire or explosion caused

by the ignit ing of vapors or dust due to the arcing of

ATTACHING

ACCESSORIES TO INLET

GUARD

■

4" Diameter Hose/Clamp Assembly and Adapter

1 O pen

Clamp

and insert

Hose,

by slipping

Clamp

;,:iC\6vet Hose.

Attach to

Inlet Guard

and tighten

v CfClampy^

a straight blade screw driver. U se this

sam e process to connect

Adapter.

Tighteh both

Clamps

securely to increase air velocity and

The Adapter will perm it easy dis-

v; :■ 7 connect.

\ ^ i

CAUTION: To avoid fire, use only the hose and

adaptor designed for this unit. The adapter is de
signed to fit only to the hose. Do not attach it directly

to any other inlet opening.

CONNECTING DUST COLLECTION
SYSTEM TO POWER SOURCE

k CAUTION: If connected to a circuit protected

by fusesi use time delay fuses with this appilance.

1. Prior to connecting your Dust Collection System to

any power source, be sure your bags are installed
properly. Thiswillremoveanypossibilityof dustflying
in your face.

2. The motor on your Dust Collection System is wired for

120 volts, single phase power system. Make sure the
motor rating agrees with the electrical system it is to
be connected to.

Too many machines on one circuitwill blow fuses.

careful not to overload

circuit.

•

electricai parts, do not operate this Dust Collection
System In areas with flammable vapors such as

lighter fluid, cleaners, oil-base paints, gasoline,

alcohol or explosive dust such as coal, magnesium,
grain or gun powder in the air. Do not vacuum
explosive dust, flammable or combustible liquids or
hot ashes. To avoid health hazards from vapors or
dusts, do not use near toxic materials. To avoid

electrical shock, do not expose to rain. Store in
doors. Unplug power cord before changing, clean

ing, or emptying the filter/dust bag or chip bag.