Craftsman 137.248850 - Manual (Page 6)

ACCESSORIES AND ATTACHMENTS CARTON CONTENTS
RECOMMENDED ACCESSORIES
A WARNING
Visit your Sears Hardware Department or see the
Craftsman Power and Hand Tools Catalog to purchase
recommended accessories for this power tool.
A WARNING
To avoid the risk of personal injury:
• Do not use adjustable (wobble) type dadoes or
carbide tipped dado blades.
• Only use stackable dadoes.
• Maximum dado width is 1/2”.
® Do not use a dado with a diameter larger than 6”.
• Do not use molding head set with this saw.
• Do not modify this power tool or use accessories
not recommended by Sears.
TOOLS NEEDED FOR ASSEMBLY
SUPPLIED
Blade wrench
NOT SUPPLIED
Medium screwdriver
Blade wrench
3 mm Hex key
#2 Phillips screwdriver
I. . . . . . . . . . . . . . . . . . . . . . . . . .
Straight edge
S)
Adjustable wrench
I I I I I I I r-n-r-j I I I I i-p
I
. I I I I I .I I I , I I I I I
Combination square
Separate all parts from packing materials. Check each
part with the illustration on the next page and the “Table
of Loose Parts” to make certain all items are accounted
for, before discarding any packing material.
A
WARNING
If any part is missing or damaged, do not attempt
to assemble the table saw, plug in the power cord,
or turn the switch ON until the missing or damaged
part is obtained and is installed correctly. To avoid
electric shock, use only identical replacement
parts when servicing double insulated tools. Call
1-800-4-MY-HOME® for replacement parts.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION
A Table saw assembly
B Rear table extension
C Rear table extension tube
D Hardware bag assembly
E Blade guard and splitter assembly
F Hardware bag assembly
G Handwheel
H Dome nut
I Rip fence
J Hex key
K Blade
L Blade wrench
M Right extension wing table
Miter gauge
Hardware bag assembly
Left table extension
Upper tube
Dust bag N
O
P
Q
R
STAND
S Floor plate
T
Stand door
U Stand base
QUANTITY
1
1
2
1
1
1 each
2
2
1
1
1
2
1
1
1
1
2
1
NOTE: To make assembly easier, keep contents of box
together. Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean dry cloth. This will
reduce friction when pushing the workpeice. To avoid
injury, the styrofoam block should be removed between
the motor and table.