Craftsman 320.28190 User Manual
Ciiftsmi
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Procfyct Manual
CiiFTSMi№
P R O F E S S I O N A L
12.5 Amp/ Variable Speed/ 2-1/4
Peak HP
Fixed Base Router
Model No. 320. 28190
A CAUTION! Read, understand and
follow all Safety Rules and Operating
Instructions in this Manual before
using this product.
Description
Operation
Adjustments
Maintenance
Troubleshooting
Sears, Roebuck and Co., Hoffman Estates, !L 60179
Table of contents
Document Outline
- ONE YEAR FULL WARRANTY ON CRAFTSMAN TOOL
- SAVE THESE INSTRUCTIONS!
- READ ALL INSTRUCTIONS!
- WARNING: BE SURE to read and understand all instructions in this manual before using this router. Failure to follow all instructions may result electric
- WORK AREA SAFETY
- PERSONAL SAFETY
- ELECTRICAL SAFETY
- EXTENSION CORDS
- SAFETY
- SYMBOLS FOR YOUR TOOL
- SERVICE SAFETY
- INSPECT the tool cords periodically and if damaged have them repaired at your nearest Sears Service Center. BE AWARE of the cord location.
- 1. 12.5 Amp, 2-1/4 Peak HP, Variable Speed Router Motor runs at 12,000 to 25,000 RPM (no-load speed).
- 9. Base features Large Base Opening and Large Chip Shield, combined with 3 LED Work lights on Router Motor to provide high visibility of bit and work piece.
- INSTALLING THE CUTTING BIT
- CAUTION: To prevent damage to tool, do not tighten collet/nut without a cutting bit installed.
- COLLET/NUT CARE
- CUTTING BITS
- INSTALLING ROUTER MOTOR IN BASE
- INSTALLING ROUTER MOTOR IN BASE (Fig. 5)
- Deep Cuts
- TOGGLE “ON/OFF” SWITCH (Fig. 7)
- SOFT START FEATURE :
- “LIVE TOOL INDICATOR” LIGHT (Fig. 9)
- HEAVY-DUTY EDGE GUIDE (Fig. 10)
- DETACHABLE POWER CORD (Fig 11)
- Electronic Variable Speed Control
- ELECTRONIC FEEDBACK CIRCUITRY
- PLACING THE ROUTER ONTO THE WORKPIECE AND STARTING THE CUT
- EDGE ROUTING OR INTERNAL ROUTING
- DIRECTION OF FEED - EXTERNAL CUTS (Fig. 16)
- CHIP SHIELD DEFLECTOR (Fig
- WARNING: The chip
- DUST COLLECTION WITH DUST EXTRACTION AD/^PTER (Fig. 2D)
- To adjust Depth with the Depth-Adjustment Wrencfi (Fig. 21}
- GENERAL
- ROUTINE MAINTENANCE
- REPLACEMENT OF CARBON BRUSHES (Fig. 22)
- LUBRICATION
- WARNING: The use of attachments or accessories that are not recommended for this tool might be dangerous and could result in serious injury.
- BER 3S>28iro^^*^ ^ R^ODEL NUM-