Writing the rc time code on a recorded tape, To stop writing the rc time code, Canceling rc time code writing – Sony CCD-TR700 User Manual

Page 39: Notes on writing the rc time code, O „ a

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Writing the RC Time Code on a Recorded Tape

You can write the RC time code on a recorded tape. Use the Remote Commander.

(1)

While pressing the small green button on the POWER switch, slide it to VTR.

(2)

Rewind the tape to

the beginning and set the camcorder to playback pause mode.

(3)

Press TIME CODE WRITE on the

Remote Commander. The TIME CODE WRITE indicator appears in the viewfinder with WRITE flashing.

(4)

Press O or

to start playback. The WRITE indicator stops flashing and the RC time code writing

starts from 0KX):00:00.

A PLAY

II PAUSE

O „ a

00:01

TIMECOOE

WRITE

;

To Stop Writing the RC Time Code

Press □ (or any tape transport button).

To Write the RC Time Code from the End of the RC Time Code Recorded Portion

Rewind the tape to the portion on which the RC time code has been written and set the camcorder to
playback pause mode. Then follow steps 3 and 4 above. The RC time code is written continuously.

Canceling RC time code writing

The RC time code writing stops when:

• you press TIME CODE WRITE again before starting playback
• you press INDEX before starting playback
• you change from playback mode to arwther mode

Notes on writing the RC time code

• When you are writing the RC time code from the middle of a tape without the time code written,

writing starts several frames before the current picture.

• You can not write the RC time cord on the tape recorded in LP mode. Though you can write it on the

tape recorded in mixed LP and SP modes, it may not be displayed correctly when the tape is played

back.