Sony MHC-RXD9 - Manual (Page 9)

Press TUNER/BAND repeatedly
until the band you want appears in
the display.
The bands you can receive vary
depending on the model you purchased.
Be sure to check which bands you can
receive.
Every time you press this button, the
band changes as follows:
2 band model:
FM-^-> AM
3 band model:
FM -> MW -♦ SW
t________ I
FM-
L
or
• A M - UKV*
"STEREO PLUS" is displayed when
you select UKV.
Press and hold -f or - until the
frequency indication starts to
change, then release.
Scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
3
Press TUNER MEMORY.
A preset number appears in the display.
The stations are stored from preset
number 1.
Preset number
h '1 1 |i <( 1 ( 1 r 1 1 1 1- ^1 'Г
M i" I 11 1 i‘i 1 1 II
г
У
•*1
4
Press ENTER/NEXT.
The station is stored.
To tune in a station with a weak
signal
Press or - repeatedly in step 2 to tune in the
station manually.
To set another station to the exist
preset number
Start over from step 1. After step 3, turn the
jog dial to select the preset number you want
to store the other station.
You can add a new preset number after the
last preset number.
To erase a preset station
1 Keep pressing TUNER MEMORY until a
preset number appears in the display.
1 1 > 1 1 1 I
— Ч *
1 l> '1 t
L 1 ' И J L 1 M 1 "
2 Turn the jog dial to select the preset
number you want to erase.
Select "ALL ERASE" when you want to
erase all the preset stations.
3 Press ENTER/NEXT
"COMPLETE" appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(Except for the European and Middle
Eastern models)
The AM tuning interval is factory set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the ENTER/NEXT
button, turn the power back on. When you change
the interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Tip
The
I
me preset stations are retained for half a
you unplug the power cord or if a power
occurs.
itcu lui iicui
a
day even if
or if a power failure
5
Repeat steps 1 to 4 to store other
stations.