Sony WEGA KV-32FS12 User Manual
Wega, Trinitroif color tv, Sony
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This manual is related to the following products:
Table of contents
Document Outline
- WARNING
- Important Safeguards
- Power Sources
- Grounding or Polarization
- For the set with a polarized AC power cord plug
- Alternate Warning
- For the set .with a three-wire
- grounding type AC plug
- Overloading
- Object and Liquid Entry
- Cleaning
- Attachments
- Water and Moisture
- Accessories
- Ventilation
- Power-Cord Protection
- Grounding or Polarization
- Outdoor Antenna Grounding
- Antenna Grounding According to the NEC
- Lightning
- Damage Requiring Service
- Servicing
- Replacement Parts
- Contents
- introduction
- Connecting Your TV
- Using the Remote Control and Basic Functions
- Using the Menus
- To access a menu
- Using the Video S Menu
- Using the Audio ^ Menu
- To access the Audio menu, see "To access a menu" on page 21.
- Treble
- Bass
- Balance
- Steady Sound
- Using the Channel Setup i3 Menu
- To access the Channel Setup menu, see "To access a menu" on page 21.
- ^ To use Favorite Channel: Exit all menus and press O. Press o or 0 to move the cursor to the desired channel number and press ®.
- ^ After you close the menu, the PIP window picture appears so you can preview the favorite channel (KV-27FS16, KV-27FV16, KV-32FS16 only).
- ^ After changing your cable settings, you will need to perform Auto Program,
- ^ Favorite Channel, Channel Skip/Add, and Channel Label cannot be used when Channel Fix is set.
- Parental Control
- Using the Parental Control^ Menu
- Using the Timer 0 Menu
- To access the Timer menu, see "To access a menu" on page 21.
- ^ You must set the Current Time before you can use Timer 1 and Timer 2.
- ^ You can set the Timer to ON, OFF, or Set. Once the timer is set, you can turn it on or off without having to go through the settings.
- When you perform Auto Program, all Timer 1 and Timer 2 settings will be cleared.
- Any loss of power will cause Current Time, Timer 1, and Timer 2 settings to be cleared.
- Using the Setup ^ menu
- Using the Basic Menu
- other Information
- Programming the Remote Control
- You can use the supplied remote control to operate Sony or non-Sony video equipment.
- 1 rress CD .
- 2 Press or (FUNCTION).
- 3 Use the (o)-(D buttons to key in the code number from the following chart.
- If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.
- ^ Whenever you remove the batteries the code numbers may revert to the factory setting and must be reset.
- ^ In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment's supplied remote control.
- Operating a VCR
- Troubleshooting
- Specifications
- Programming the Remote Control