Camcorder, Trouble check – Sony CCD-TR714 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Trouble Check
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.
Camcorder
Power
Symptom
Cause and/or Corrective Actions
The power is not on.
• The battery pack is not attached or not attached firnriy.
Attach the battery pack firmly by pushing the lower part of
the battery pack. (p. 9)
• The battery is dead.
Use a charged battery pack. (p. 6)
• The AC power adaptor is not connected to a wall outlet.
Coanect the AC power adaptor to a wall outlet, (p. 21)
The power goes off.
• While being operated in CAMERA mode, the camcorder has
been in the Standby mode for more than 5 minutes.
Turn STANDBY down once and turn it up again, (p. 12)
• The battery is dead.
-> Use a charged battery pack. (p. 6)
The battery pack is quickly
• The ambient temperature is too low. {p.
M )
discharged
• The battery pack has not been charged full\'.
Charge the battery pack again, (p. 6)
• The battery pack is completely dead, and cannot be recharged.
Use another battery pack. (T. 35)
Operation
Symptom
Cause and/or Corrective Actions
START/STOP does not
• The tape is stuck to the drum.
Operate.
-> Eject the cassette, (p. 10)
• The tape has run out.
Rewind the tape or use a new one. (p. 19)
• The TOWER switch is set to PLAYER,
^Set to CAMERA, (p. 11)
• The tab on cassette is out (red).
Use a new cassette'or slide the tab. (p. ¡0)
The cas,sette cannot be
• The battery is dead.
removed from the holder.
Use a charged battery pack or the .AC power ad.iptor. (p. 6, 21)
\'o function except for
• Moisture condensation has occurred.
cassette ejection works.
Remove the cassette and lea\ e the camcorder for at least an
hour. (p. 38)
The tape does not move whe
n • The POWER switch is set to C.AMHRA or OFF,
a tape transport button is
-»Set it to PLAYER, (p. 19)
pressed.
• The tape has run out.
-> Rewind the tape or use a new one, (p. 19)
-<
O
( Ì O
be continued)
43