To tune in a station with a weak signal, To set another station to the exist preset number, To erase a preset number – Sony MHC-RXD2 User Manual
Page 7: Connecting outdoor antennas, Fm antenna, Am antenna, Connecting outdoor anteimas
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3
Press TUNER MEMORY.
A preset number flashes in the display.
c: n n p u c
^
I I L I l U I ' J I I I
V
Preset number
4
Press ENTER/NEXT.
The station is stored.
5
Repeat steps 1 to 4 to store other
stations.
To tune in a station with a weak
signal
When the desired station is skipped during
autonvatic tuning, press - or + repeatedly in
step 2 to tune in the station manually.
To set another station to the exist
preset number
Start over from step 1. After step 3, press 1«
or repeatedly to select the preset number
you want to store the statioir.
To erase a preset number
1
Press and hold TUNER MEMORY until the
preset number flashes in the display.
2 Press or repeatedly to select the
preset number you want to er«ise.
If you want to erase all preset numbers,
select "ALL ERASE".
3
Press ENTER/NEXT.
When you erase a preset number, the total
number of preset stations decreases by one.
You can add a new preset number after the
last preset number.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Connecting outdoor
antennas
Connect the outdoor anterma to improve the
reception.
FM antenna
Connect the optional FM outdoor anterma.
You can also use the TV antenna instead.
75ohm coaxial cable
(not supplied)
AM antenna
Coimect a 6- to 15- meter (20- to 50- feet)
insulated wire to the AM anteima terminal.
Leave the supplied AM loop antenna
connected.