Sony MHC-RXD2 - Manual (Page 11)

1 Press TUNER/BAND repeatedly
until the band you want appears in
the display.
Every time you press this button, the
band changes as follows;
FM.^AM
2
Press or repeatedly to
tune in the desired preset station.
Press for lower preset numbers.
Press for higher preset numbers.
S»
1
VOLUME
— - p M 8 8
.
0
. „
Preset number Frequency
To Do this
Turn off the radio Press l/C!) (power).
Adjust the volume Turn VOLUME (or press
VOL +/- on the remote).
To listen to non-preset radio
stations
Automatic tuning
Press and hold - or + (■♦remote) in step 2 until the frequency
indication starts to change, then release it.
Manual tuning
Press - or + (◄◄/►► on the remote)
repeatedly in step 2 to tune in ttie station.
Tips
• Pressing TUNER/BAND when the system is off
automatically turns the system on and times in the
last received station (One Touch Play).
• You can switch from another source to the radio
)ust by pressing TUNER/BAND (Automatic
Source Selection).
• When an FM program is noisy, press
STEREO/MONO so that "MONO" appears in the
display. There will be no stereo effect, but the
reception will improve. Press the button again to
restore the stereo effect.
• To improve broadcast reception, reorient the
supplied antennas.
Recording from the
radio
You can record the radio program on a tape
by calling up a preset station. You can use a
TYPE I (normal) tape.
1/Ö
(power) TAPE B I
1 4
1
Press TUNER/BAND to select the
band you want.
2
Press Wd or ►►) repeatedly to
tune in the desired preset station.
Press 1« for lower preset numbers.
Press for higher preset numbers.
Preset number Frequency
m
»I;
continued