Sony SPP-900 - Manual (Page 9)

Redialing
1
Press (TALK/FLASH).
The TALK/BATT LOW lamp lights up.
2
Press (REDIAL) to redial the number last dialed.
Note
If the number last dialed exceeds 16 digits, only the first 16 digits are dialed.
Speed dialing
You can dial with a touch of a few buttons by storing a phone number on a
dialing button. You can store up to 10 different phone numbers.
Storing phone numbers
Press (PGM).
The TALK/BATT LOW lamp flashes.
Press one of the dialing buttons (®
to CD) for the phone number to be
stored.
Enter the phone number you want to
store.
You can enter up to 16 digits,
including a tone and a pause, each of
which is counted as one digit.
Press (SPEED DIAL).
You'll hear a long confirmation beep,
and the number is stored. The TALK/
ВАТТ LOW lamp goes off.
Notes
• In step 3, if you don't enter the phone number, the previously stored number will be
erased.
• Do not allow more than 30 seconds to elapse between each step of the procedure.
• Before storing phone numbers, make sure the handset is not in use.
Tips
• If you enter a wrong number, start from the beginning.
• Use the supplied directory to write down what you stored on the speed dialing numbers.
To store the previous number dialed
Press (REDIAL) directly after step 2, then go to step 4.
To store a number to be dialed via Private Branch Exchange (PBX)
Before entering a phone number in step 3, do as follows:
1
Enter the outside line access digit (e.g. 9).
2
Press and hold the number button down before the position where
the pause is to be inserted.
For example, 9, pause, 555-1234 would be programmed by pressing
and holding the 9 button until it beeps twice, then entering 5, 5, 5,1, 2,
3, 4. The pause is two seconds in length. To enter a longer pause,
press and hold the button down imtil the handset beeps three or four
times. Each additional beep indicates an additional two second pause.
Note
Each pause is counted as a digit.
To change a stored number
To store a new number, follow the instructions described previously.
Making calls with speed dialing
1
Press (TALK/FLASH).
The TALK/BATT LOW lamp lights up.
2
Press (SPEED DIAL).
3 Enter the desired speed dialing number ((® to CD)-
The phone number stored in the speed dialing number will be dialed.