Sony SPP-900 - Manual (Page 8)

To obtain the best performance from battery
1X> not pl.ia- till’ li.milsi't on the b.iso unit .ittor o.ii'h call. Tho battorv uoiLs best it
till’ liandsot is roturnod to tho base unit after two or throo calls. Howo\ or, do not
loavo tho handsot oft tho baso unit for a loni; poriiKf of timo as this will
complotolv dischargo tho batton- pack.
If the handset battery becomes weak
Whon not com orsing with an outside caller, tho TALK/BATT LOW lamp on tho
handsot flashes if tho handsot is not placed on tho base unit. Replace tho handsot
to tho base unit to recharge tho battery for more fhan
10 hours.
When to purchase a new battery pack
If fho baftorv lasfs only a few minufes even affer 10 hours of charging, the usable
life of the battery has expired and needs replacement. Contact your local Sony
authorized dealer or service center, and ask for a Sony BP-T23 rechargeable
bafferi' pack.
Note
Battery life may \ ary depending on usage condition and ambient temperature.
Making and receiving calls
1
2
3
Press (TALK/FLASH).
TALK/BATT LOW lamp lights up,
then you'll hear a dial tone. If you
hear beeps, move closer to the base
unit.
Dial the phone number.
When you're done talking, press
(OFF) or replace the handset on the
base unit.
The TALK/BATT LOW lamp goes
off.
Receiving calls
1
When you hear the phone ring;
• Press (TALK/FLASH) (or any key except (OFF)).
or
• Pick up the handset from the base unit when the handset is
placed on the base unit.
The TALK/BATT LOW lamp lights up at the same time the LINE
lamp on the base unit lights up.
^ When you're done talking, press (OFF) or replace the handset on the
base unit.
The TALK/BATT LOW and LINE lamps go off.
Additional tasks
To Do this
Select a better channel Press f CHANNEL).
Adjust the ringer
volume Set the VOL switch to H (high), M (medium) or L (low).
Switch to tone dialing
temporarily Press ( *TONE ) while usinc the telephone after vouTe
connected. The line remains in tone dialing until disconnected.
Switch to another call
("call waiting" service*)
Press ( TALK/FLASH ) to access the flash function.
Press f TALK/FLASH ) again to return to the first caller.
• Contact your telephone company to subscribe to this service.
Notes
• Before dialing, make sure you can hear the dial tone, otherwise you cannot dial correctly.
• When the TALK/BATT LOW lamp lights up by pressing C
tali ^FLASH/. the LINF. lamp
on the base unit lights up simultaneousiv'