Sony CCD-FX310 - Manual (Page 26)

Checking the Last Po a Sceh^ VoU JU^t PeedRIed (Rec №vte
You can check the last portion of a scene you just recorded without changing the setting of
the POWER switch using EDITSEARCH.
1
Put the camcorder in the standby mode by
pressing the START/STOP button.
Press the - is) side of EDITSEARCH momentarily.
The last few seconds of the recorded portion will be
played back in the viewfinder. After a few seconds of
playback, the camcorder goes back to the standby
mode, ready for the next recording.
c
+ EDITSEARCH
Note on using EDITSEARCH
When you raise the viewfinder and use EDITSEARCH,
hold the viewfinder with your thumb to prevent
movement. EDITSEARCH
button
Checking Recording In the Viewfinder (EDITSEARCH)
You can check the recorded picture in the viewfinder using EDITSEARCH. Sound cannot
be monitored.
1
Press the small green button, and slide
the POWER switch to CAMERA.
Set the STANDBY switch up.
START/STOP
Keep pressing the + or - side of EDITSEARCH to
view the playback picture:
^
+ side for the playback picture ^
- side for the playback picture in reverse. + EDITSEARCH - ©
To stop playback
Release EDITSEARCH.
To monitor the sound while viewing the playback picture in the viewfinder
1 Connect an earphone to the ® (earphone) jack.
2 Press the small green button and slide the POWER switch to PLAYER.
3 Press ◄◄ to rewind the tape and press □ where you want to stop.
4 Press C> to start playback.
26
Advanced Camera Operation