Set the power switch on the camcorder as foliows, I rt, L-i i – Sony CCD-FX310 User Manual

Page 19: Г|1. i, 1111 hi i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

! Г|1. i

i rt

; Г4|

L-i

1111 hi I [■

By using the Remote Commander, you can be in the picture with your friends and family,

or conveniently control the playback of your tape from a distance.

Insert two size AA (R6) batteries with

the + and - ends properly
positioned.

Set the H REMOTE COMMANDER

switch on the battery mounting surface
of the camcorder.

If the battery is attached, remove it.
Reattach the battery after setting the
REMOTE COMMANDER ON/OFF switch.

Set the POWER switch on the camcorder as foliows:

— When camerarecording, 1) press the small green button on the POWER switch

and slide it to CAMERA, 2) set the STANDBY switch up.

— When playing back, slide the POWER switch to PLAYER.

Aim the Commander at the remote
sensor on the camcorder and

m (6.6

press the appropriate button on

the Commander.

-Remote sensor

'2 m (6.6 ft)

(Approximate maximum distance and angles for remote control)

HOLD

Note on the Remote Commander

• Keep the remote sensor away from strong light sources such as direct sunlight or illumination

Remote control with the Commander may not function properly ander such circumstances.

• The command mode of the Commander is VTR2 Avoid using the Sony VCRs with the same

command mode at the same time

Getting familiar with some buttons

HOLD switch
When you slide the switch in the direction of the
arrow, all the buttons will become inoperable to
prevent any misoperation should you
accidentally press the buttons.
!► SLOW and DATA SCREEN buttons
You can use the functions of these buttons only
with the Commander.

-!► SLOW

-DATA SCREEN

Battery life

In normal operation, batteries last up to

six

months.

the camcorder does not

operate properly, the batteries might be exhausted. Replace both batteries with new ones

To avoid damage from possible battery leakage

Remove the batteries when you will not use the Commander for a long time.

When you connect the receiver of a remote control kit

When you connect the receiver of a remote control kit (not supplied) to the REMOTE

control connector, be sure to set the H REMOTE COMMANDER switch on the battery

mounting surface of the camcorder to OFF.

Basic Camera Operation "j Q