Camcorder – Sony CCD-TR416 User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

It run into .in\ problem using the camcorder, use the following table
to
troubleshoot the problem. Should the difficulty persist, disconnect the power source
and contact your Son\’ dealer or local authorized Sr)n\ serx ice facility.
Camcorder
Power
Symptom
Cause and/or Corrective Actions
The power is not
on.
• The battery pack isTidt installed.
Install the battery pack. (p. 6)
• rhe battery is dead.
Use a charged battery pack. (p. 7)
• The AC power adaptor is not connected tc) a wall outlet.
Connect the AC povx er adaptor to a wall outlet, (p. 22)
The power gi>es off.
• While beini; operated in CAMHKA mode, the camcorder
has been in Standby mode for more than 5 minutes.
Turn STANDBY down once and then up again, (p. 12)
• I'he battery is dead.
-> Use a charged battery pack. (p. 7)
] he battery pack is quickly
discharged.
• The camcorder does ncT operate when using a batterx'
pack that is not an "inhd ,1T1 HUM’' batlerx’ pack.
Use an "InfoPITHlUM” battery pack. (p. 56)
• The ambient temperature is too low. (p. 55)
• The battery pack has not been charged fully.
Charge the battery pack again, (p. 7)
• The battery pack is completely dead, and cannot be
recharged.
-> Use another battery pack. (p. 55)
While charging the battery pack, no
indicator appears or the indicator
flashes in the display window.
• The .AC power adaptor is disconnected.
-> Connect it firmly.
• Something is wrong with the battery pack.
-> Contact your Sony dealer or local authorized Sony
service facility.
Operation
Symptom
Cause and/or Corrective Actions
S TART/STOP dtK's not operate.
• The tape is stuck to the drum.
Tject the tape. (p. 10)
• The tape has run out.
-) Rewind the tape or use a new one. (p. 10, 19)
• The POWER switch is set to PLAYER.
^ Set it to CAMERA, (p. 11)
• The tab on the cassette is out (red).
Use a new tape or slide the tab. (p. 10)
Recording stops in a few .seconds.
• The START/STOP MODE switch is set to 5SEC or ANTI
GROUND SHOOTING i, .
Set it to A . (p. 15)
(to be continued)
63