Sony CCD-TR98 - Manual (Page 41)

Precautions
Camcorder Operation
• Operate the camcorder using 6.0 V (battery pock), or 7.5 V (AC power adaptor).
• For DC or AC operation, use only the recommended accessories.
• Should any solici object or liquid fall into the casing, unplug the camcorder and have it checked by your
nearest Sony dealer before operating it any further.
• Avoid rough handling or mechanical shock. Be particularly careful of the lens.
• Keep the POWER switch set to OFF when not using the camera.
• Do not wrap up the camcorder and operate it since heat may build up internally.
• Keep the camcorder away from strong magnetic fields or mechanical vibration.
Built-in li^ht
• Do not knock or jolt the built-in light while it is turned on as it may damage the bulb oi shorten the
life of the bulb.
• Do not leave the built-in light on while it is resting on or against something; it mav cause a fire or
damage the built-in light.
On Handling Tapes
Do not insert anything in the small holes on the rear of the cassette. These holes are used to sense the
type of tape, thickness of tape and if the recording tab is out or in.
Camcorder Care
• When the camcorder is not to be used for a long time, disconnect the power source and remove the
cassette. Periodically turn on the power, operate the camera and player sections and plav back a
tape for about 3 minutes.
• Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens, remot e them
with a soft cloth.
• Clean the camcorder body with a soft dry cloth, or a soft doth lightly moistened with a mild
detergent solution. Do not use any type of solvent which may damage the finish.
AC Power Adaptor
charging
• Use only for the specified battery pack.This uiiit cannot be used to charge a lithium ion type
battery,
• Attach the battery pack firmly.
• Place the battery pack on a flat surface without vibration during charging.
Others
• Unplug the unit from the wall (mains) outlet when not in use for a long time. To disconnect the
cord (mains lead), pull it out by the plug. Never pull the cord itself.
• Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
• Do not bend the AC power cord (mains lead) forcibly, or put a heavy object on it. This will damage
the cord and may cause a fire or an electrical shock.
• Be sure that nothing metallic comes into contact with the metal parts of the connecting plate. If this
happens, a short may occur and the unit may be damaged.
• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit,
• While the unit is in use, particularly during charging, keep it awav from .AM receivers and \ ideo
equipment because it will disturb AM reception and video operation.
41