beautypg.com

Note on the remaining battery indicator, Notes on the rechargeable battery pack, Caution – Sony CCD-TR98 User Manual

Page 35: The battery heats up, Battery pack care, How to use the switch on the battery pack, The life of the battery pack, Charging temperature, Sony batteries are recommended, Tips for using the battery pack

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Tips for Using the Battery Pack

When the remaining battery indicator reaches the lowest point, the indicator appears and starts
flashing in the viewfincier.
When the cX] indicator in the viewfincier disappears and the battery lamp flashes rapidly, turn the

POWER switch to OFF on the camcorder and replace the battery pack. Leave the tape in the camcorder to

obtain smooth transition between scenes after the battery pack has been replaced.

Note on the remaining battery indicator

The remaining battery indicator of the camcorder may indicate a different remaining capacity from
that of the battery pack with the remaining battery indicator (not supplied). The indicator of the
battery pack is more accurate.

Notes on the Rechargeable Battery Pack

Caution
Never leave the battery pack in temperatures above 140°F (60°C), such as in a car parked in the sun
or under direct sunlight.

The Battery Heats Up
During charging or recording, the battery pack heats up. This is caused by energy that has been
generated and a chemical change that has occurred inside the battery pack. Tliis is not cause for concern

and is normal.

o
c

Battery Pack Care
• Remov'e the battery pack from the camcorder after using it, and keep it in a cool place. When the

battery pack is installed to the camcorder, a small amount of current flows to the camcorder even if
the POWER switch is set to OFF. This is shortens battery life.

• The battery pack is alw'ays discharging even when it is not in use after charging. Therefore, you

should charge the battery right before using the camcorder.

How to Use the Switch on the Battery Pack

When the switch is supplied with the battry pack

([a]

on p. 36) you can use it to find whether the

battery pack is charged or not. Set the switch to the "no mark" position when charging is completed.
Set the switch to the "rod mark" position when the battery is used up (or in whichever direction you
w'ant to remind yourself).

The Life of the Battery Pack
If the battery lamp flashes rapidly just after turning on the camcordrer with a fully charged battery
pack, the battery pack should be replaced with a new fully charged one.

Charging Temperature
You should charge batteries at temperatures from 50°F to 86°F (from U) 'C to 30°C). Lower
temperatures require a longer charging time.

Sony Batteries are Recommended
Use of non-Sony batteries may damage your Handycam camcorder.

35

This manual is related to the following products: