Replacing the bulb, Caution – Sony CCD-TR98 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing the Bulb
Use the Sony XB-3D lialogen lamp (not supplied).
Remove the power source before replacing the bulb.
(
1
)
While pushing the hole under the built-in light unit using a wire, remove the unit.
(
2
)
Turn the bulb housing counterclockwise and detach from the built-in light unit.
(3)
Replace the bulb using a dry cloth.
(4)
Attach the bulb housiirg turning it clockwise, then replace the built-in light unit.
CAUTION
• When replacing the bulb, use only the Sony XB-3D halogen lamp (not supplied) to reduce the risk
of fire.
♦ To prevent possible burn hazard, disconnect the power source before replacing and do not touch
the bulb until the bulb becomes cool enough to handle (for about 30 minutes or more).
Note
To prevent the bulb from being smudged with finger prints, handle it with a dry cloth, etc. If the
bulb is smudged, wipe it completelv-
23