beautypg.com

Operating a cable box or dbs receiver – Sony KP-41T35 User Manual

Page 37

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Operating a cable

box or DBS receiver

3

Press DBS/CABLE (POWER) to turn on the

cable box or DBS receiver.

DBS/CABLE

You can program the supplied remote control to

operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code

number in the remote'control.

DISPLAY*

JUMP

TV/DBS*

CODE SET

DBS/CABLE (POWER)

DBS/CABLE

(FUNCTION)

■ 0 - 9 buttons

ENTER
GUIDE*

*i*i*t*i Cj^) *

MENU*

- CH ■)•/-

The TV/DBS, GUIDE, DISPLAY, ♦/■»/♦/
buttons can be used only with a DBS receiver.

, and MENU

Turn off the equipment you want to set up,

and press DBS/CABLE (FUNCTION).

Press the CODE SET, DBS/CABLE (FUNCTION),
and 0-9 buttons to enter the

manufacturer's code number (see the chart
on the right column), then press ENTER. For

example, to program your remote control

to operate a Sony DBS receiver, press CODE
SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.

------ FUNCTION---------

CODE SET DBS/CABLE

+ CO +

4

Use the cable box/DBS control buttons to

check if the code number works.

For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+ /-, 0-9 and ENTER buttons.

Note

• If the cable box or DBS receiver does not have a certain

function, the corresponding button on this remote control will
not operate.

To operate the projection TV

Press TV (FUNCTION). Then use the projection TV

control buttons to control the projection TV.

For more details on operating the cable box or
DBS receiver

Refer to the operating instructions that come with the

equipment.

If the remote control doesn't work

• Eirst, try repeating the setup procedures using the other codes

listed for your equipment.

Manufacturer code numbers (cable box)

Manufacturer

Code number

1 liimlin/Rcgal

222, 223, 224, 225, 226

|uri‘old/C^. 1.

201,202, 203, 204, 205, 206, 207, 208,
218

0.1 к

227, 228, 229

Panasonic

219, 220, 221

I’ioneor

214, 215

Scientific Atlanta

209, 210, 211

Tocom

216, 217

Zenith

212,213

Manufacturer code numbers (DBS receiver)

Manufacturer

Code number

Sony

801 (preset code for the supplied

remote control)

RCA

802

Notes

• If more than one code number is listed, try entering them one

by one until you come to the correct code for your equipment.

• If you enter a new code number, the code number you

previously entered at that setting is erased.

• In some rare cases, your equipment may use a code that is not

provided with this remote control and you may not be able to
operate your equipment with the supplied remote control. In
this case, use the equipment's own remote control unit.

• Whenever you remove the batteries — to replace them, for

example — if too much time is taken, the code numbers may
revert to the factory setting and must be reset.

Operations

37-EN