Sony KP-41T35 - Manual (Page 36)

MDP manufacturer code numbers
Manufacturer Code number
Sony 701
Kenwood 707
Magnavox 703
Maranz 702
Mitsubishi "■ 702
Panasonic 704
Philips 703
Pioneer 702 ^
RCA 702
Sanyo 706
Sharp 705
Yamaha 703
Operating video equipment
Notes
• If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment.
• In some rare cases, you may not be able to operate your non-
Sony video equipment with the supplied remote control. This
is because your equipment may use a code that is not included
with this remote control. In this case, please use the
equipment's own remote control unit.
• The code numbers for Sony equipment are assigned at the
factory as follows:
301 (preset code for the supplied
remote control)
302
303
Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code number may
revert to the factory setting and must be reset.
VHS VCR
8 mm VCR
Beta, ED Beta VCRs
VTR (FUNCTION)
Video operating
buttons
VTR (POWER)
0-9 buttons
ENTER
CH +/-
Use the video operating buttons on the remote
control to operate the video equipment.
Press VTR (FUNCTION) before operating the
video equipment.
Operating a VCR Buttons on the remote control
To turn on or off Press VTR (POWER).
To select a channel
directly Press the 0-9 buttons.
To change channels Press CH +/-.
To record Press ► while pressing •. First release
►, then release 9
.
To play Press ►.
To stop Press ■.
To fast forward Press
To rewind the tape Press
To pause Press II.
To resume normal playback, press again.
To search the picture
forward or backward Press ►► or during playback.
To resume normal playback, release the
button.
To change input mode Press TV/VTR.
Operating an MDP Buttons on the remote control
To turn on or off Press VTR (POWER).
To play Press ►.
To stop -. ^ Press ■. -
To pause Press II.
To resume normal playback, press again.
To search the picture
forward or backward Keep pressing ►► or during
playback.
To resume normal playback, release the
button.
To search the chapter
forward and backward Press CH +/-.
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote control will not operate.
Operations