Sony MHC-331 - Manual (Page 9)

To stop shuffle play
Press ■ on the CD player.
To cancel shuffle play
Press PLAY MODE repeatedly until
"SHUFFLE" disappears from the display.
The tracks continue playing in their original
order.
To select a desired CD
Press DISC 1-3 during shuffle play.
To skip an undesired track
Press > on MULTI CONTROLLER (or
press on the remote).
Playing Tracks in the
Desired Order
(program play)
You can make a program of up to
32 tracks from all the CDs in the order you
want them to be played.
8
2
1 Press FUNCTION repeatedly until "CD"
appears in the display.
2
Press OPEN / CLOSE and place the
CDs on the disc tray. Then, press
& OPEN / CLOSE again to close the disc
trav.
3
Press PLAY MODE repeatedly until
"PROGRAM" and "DISC" appear in the
display.
r 71 / .
L II I
^ ^
Press DISC 1 - 3 to choose a CD.
5
Press or ^ on MULTI
CONTROLLER to choose a track.
The track number and the total playing
time appear.
Track number
jp a? ,3?
r Ti (
L t __________ 8 .3.WS. ii
Total playing time
6
Press ENTER/NEXT.
The chosen track number lights up in
the music calendar. If the track number
and the total playing time disappear
before you press ENTER/NEXT, go
back to step 5.
7
Repeat steps 5 and 6 to program
additional tracks from the same CD.
Repeat steps 4 to 6 to program
additional tracks from another CD.
8
Press >HS.
All the tracks play in the order you
choose.
To Press
Check the
program CHECK on the remote
repeatedly*’
Program a pause >011*- (II on the remote)
Stop play ■ (■ on the remote)
Cancel program
play PLAY MODE*'’
repeatedly until
"PROGRAM" or
"SHUFFLE" disappear
Erase a track
from the end CLEAR on the remote in
stop mode
Erase a specific
track CHECK on the remote
repeatedly so that the
number of the track
lights up, and press
CXEAR on the remote
Erase the entire
program ■ (■ on the remote)
once in stop mode or
twice while playing
After the last track appeared "CHECK
END" appears in the display.
"F' appears and the total playing time is
reset to 0.00.
The program is erased.
To change the order of
programmed tracks
To change the order, erase the entire
program and create a new one.
Notes
• The program you made remains in the CD
player even after it has been played back.
Press >110 to play the same program again.
• If appears instead of the total
playing time during programming, this
means:
- you have programmed a track number
which exceeds 20, or
- the total playing time has exceeded 100
minutes.
Playing Tracks
Repeatedly
(repeat play)
The repeat play function repeats a single
CD or all CDs in normal play, shuffle play
and program play.
Use the buttons on the unit to do this
operation.
1/ALL DISCS
Repeating alt the tracks
1 Press REPEAT a few times until
"REPEAT" appears in the display.
S>9 3>
continue to next page -»
Chapter 2: the CD Player I 0