Sony CDP-C9ESD - Manual (Page 5)

Installation
Notes on Installation
Place the unit in a location with adequate air circulation
to prevent internal heat build-up in the unit.
This way.
Do not place the unit on a soft surface, such as a rug
that would block the ventilation holes on the bottom.
Not this way.
• Do not install the unit:
— near heat sources such as radiators or air ducts.
— in a place subject to direct sunlight, excessive dust, mechanical vibration or shock.
■ Do not move the unit while the disc magazine is inside, otherwise the discs may fall out of the magazine and you will be
unable to remove them.
Installing Batteries
Install the batteries In the supplied remote commander
for remote control operation.
On moisture condensation
If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lens inside the unit.
Should this occur, the player will not operate. In this
case, remove the disc and leave the player turned on for
about an hour until the moisture evaporates.
Do not throw away the carton and the packing material
It will be an ideal container in which to transport.
To avoid damage caused by battery leakage and corrosion
When the commander will not be used for a long time, remove the
batteries.
On battery life
About half a year of normal operation can be expected when using
Sony SUM-3 (NS) batteries.
When the batteries are low, the remote commander will not operate
the unit. In this case, replace both batteries with new ones.