Compex Technologies NetPassage 15B - Manual (Page 51)

Appendix A Console Commands
44
forwarding. You may obtain the by listing the defined IP
forwarding table with the command “SHOW IP STATIC NAT TABLE”
DELETE PORT STATIC NAT Delete an entry from the list of defined virtual server based on port
forwarding. You may obtain the by listing the defined port
forwarding table with the command “SHOW PORT STATIC NAT
TABLE”
DELETE DHCP RESERVE Delete a DHCP reservation from the list. The is the sequence
from top by listing the DHCP reservation table with the command
“SHOW DHCP RESERVE”
DELETE FILTER Delete an IP packet filtering rule. You may obtain the by
listing the defined IP filtering rule with the command “SHOW FILTER”
RESET Command
SYNTAX DESCRIPTION
RESET SYSTEM Reboot the router
RESET CONFIG Reset the configuration back to factory defaults
ADD Command
SYNTAX DESCRIPTION
ADD IP ROUTE Add an entry to the routing table
ADD IP STATIC NAT Add a virtual server based on IP forwarding
ADD PORT STATIC NAT
“” Add a virtual server based on Port Forwarding
ADD DHCP RESERVE “NAME>” Add a DHCP reservation
ADD FILTER Add a IP packet filtering rule
ENABLE Command
SYNTAX DESCRIPTION
ENABLE RIP Enable RIP version 1 or 2
ENABLE NAT Enable Network Address Translator
ENABLE DHCP SERVER Enable DHCP server
DISABLE Command
SYNTAX DESCRIPTION
DISABLE RIP Disable RIP
DISABLE NAT Disable Network Address Translator
DISABLE DHCP SERVER Disable DHCP server
SAVE Command
SYNTAX DESCRIPTION
SAVE CONFIG Save the changes in configuration to the router’s flash ROM
DISCONNECT Command
SYNTAX DESCRIPTION
DISCONNECT TELNET SESSION Disconnect from the TELNET console management
EDIT Command
SYNTAX DESCRIPTION
EDIT FILTER Edit a defined IP packet filtering rule