Compex Technologies NetPassage 15B - Manual (Page 33)

Chapter 3 Configuring NetPassage 15B
26
4. Enter the Username, Password and Idling Timeout value to the fields and press
the Save button.
5. Press the Reboot button to complete the configuration process.
3.2.5 Australia Big Pond Cable Internet
You should select this WAN type only if you are a subscriber of Big Pond Cable
Internet in Australia. If you have subscribed to OPTUS in Australia, please go to
Section 3.2.1 titled Cable Internet with Dynamic IP Assignment. Please note that
OPTUS requires a DHCP Client ID before releasing an IP address to you.
1. Click on the WAN Setup URL from the Command Menu and the WAN
configuration page will be displayed, as shown in Figure 3.2.2-1.
2. Press the Change button and the list of supported WAN type will be displayed, as
shown in Figure 3.2.1-2.
3. Check the Australia BPA Cable radio button and press the Save button. The
configuration page for Big Pond Australia will be displayed, as shown in Figure
3.2.5-1.
Figure 3.2.5-1
Big Pond Australia
Configuration Page
4. Enter the Username, Password and Idling Timeout to the fields and press the
Save button.
5. Press the Reboot button to complete the configuration process.
3.3 Network Address Translator (NAT)
Compex NetPassage 15B has been designed with a Network Address Translator (NAT)
that supports Port Address Translation (PAT), sharing a single public IP address with
multiple computers in the private network by using different TCP ports for different
computers. By default, the NAT is enabled.