Compex Technologies NetPassage 15B - Manual (Page 45)

Chapter 3 Configuring NetPassage 15B
38
3.7.1 Implementing Parallel Broadband
To implement Parallel Broadband, you need to install two or more units of NetPassage
15B in the network, each connected to its broadband Internet service account. There is
no restriction on the type of broadband Internet accounts that they are connected to. For
example, if you have two NetPassage 15Bs in the network, you may have one connected
to Cable Internet whereas the other connected to ADSL line. Once the Parallel
Broadband is implemented, these two NetPassage 15Bs will balance the Internet traffic
among them while functioning as Fail-Over Redundancy to each other.
To activate Parallel Broadband:
1. Click on the Parallel Broadband URL from the Command Menu and the Parallel
Broadband activation page will be displayed, as shown in Figure 3.7.1-1.
Figure 3.7.1-1
Activating Parallel
Broadband
2. Check the Enable radio button and press the Apply button.
NOTE
You DO NOT need to implement Parallel Broadband for Internet sharing
using one unit of NetPassage 15B.