Sony SPP-M920 - Manual (Page 14)

Basics
Making calls
VOL +/-
ogo’
©go
CINTERCOMPEL)
Additional tasks
1 Pick up the handset from the
base phone.
Fully extend the antenna.
Press ( LINE 1 ) or ( LINE 2) and
wait until the line icon — is
displayed and you hear a dial
tone.
If you hear beeps, move closer
fo fhe base phone.
Dial the phone number.
The line indication (Q or B)
will follow the number.
(You can also dial the number
before pressing (LINE 1) or
( LINE 2).)
Note
You can insert a two second pause in the
dial string by pressing (
hold / pause
).
When you're done talking,
ress (OFF) or replace the
andset on the base phone.
E
To Do this
Put calls on hold Press ( HOLD/PAUSE ) to place all calls on hold.
Press ( LINE 1 ) or ( LINE 2 ) to cancel hold on just one line.
Switch to tone dialing
temporarily Press ( *TONE) after you're cormected.
The line will remain in tone dialing until disconnected.
Clear a number or the
entire display in pre-dial Press ( INTEHCOM/DEL) for more than one second to delete
the last digit entered. Press and hold ( CONF/CLEAR) for
more than one second to clear the entire display.
Adjust the volume Press VOL -F/- until the desired level is reached.
Make a call on the other
line Place the current call on holcfbv pressing ( HOLD/PAUSE).
Press ( LINE 1 ) or ( LINE 2), whichever is not in use.
Dial thè newTmmber. (See page 24 for conference calls.)
Basics