Sony KP-53V15 - Manual (Page 70)

Using the Pre-Programmed Remote Commander
Operating a cable converter box
Follow these instructions to set the manufacturer’s code,
which will enable you to operate a connected cable
converter box with the pre-programmed Remote
Commander.
Example: Operate a connected Zenith cable converter box.
Remote Commander
(with video control cover open)
MUTM6 CUPTKN SLEEP POWER
OO 1=11=1
CHf FREEZE tV/VIDEO SWAP PIP
1=1 a 1=11=1 o
CH- POSITION AUDIO OFF
1=1 1=11=10
0 © ©
© © ©
© 0 ®
IISPLAY —V enter
O ©O
TVWIDEO
i=l
ANT/AUXl
JUMP
(=]
A/VWINOOW VOL CH
+
MENU
+
return '«™«
l C=|CE)
FWORITE
VTRL-2-3 mop TV CABLE BOX
TV/VTR CODE SET STANDARD
a □ —
1 Set the TV/CABLE BOX selector to CABLE BOX.
TV CABLEBOX
2 While pressing CODE SET, press 6 and 8 (Zenith's
code number — see Fig. 8) and ENTER.
CODE SET
5
ENTER
3 Use the projection TV control buttons (POWER, 0-9,
ENTER and CH +/-) to operate the cable converter
box.
POWER
%
0 ® ®
0 ® ®
©®®
s
CH
To return to the normal screen
Set the TV/CABLE BOX selector to TV; then use the
projection TV control buttons to control the projection TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Fig. 8: Cable box manufacturer code numbers
MANUFACTURER CODE
JERROLD 60,61,62,63,64,65
PIONEER 69,70
SCIENTIFIC ATLANTA 66,67
TOCOM 71,72
ZENITH 68
Notes
• If more than one code number is listed, try entering them one by
one, until you come to the correct code for your equipment.
• If you enter a new code number, the code number you previously
entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this Remote Commander and you may not be able
to operate your cable converter box with the supplied Remote
Commander. In this case, use the equipment’s own remote
control unit.
70 I
Chapter 3: Using Advanced Features