Adjusting the picture position, Displaying the picture at the actual resolution, Customizing your monitor – Sony CPD-L150 User Manual
Page 12: Am pitch
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Customizing Your Monitor
Adjusting the Picture Position
If the picture is not in the center of the screen, press the
AUTO button. If this operation does not work, adjust the
centering as follows.
Once the centering is adjusted, it will be stored in memory
for the current input signal.
1
Load the Utility Disk (page 10).
2
Press the MENU button.
The MENU OSD appears.
MENU
PHASE
am PITCH
CSGENTER
SSZOOM
B COLOR
3
Press the buttons to select CENTER, and press
•the MENU button again.
The CENTER OSD appears.
o(^
CENTER
B 26 □
Displaying the Picture at the
Actual Resolution
The monitor is set at the factory to display the picture on the
screen in full, irrespective of the picture's resolution. You
can also view the picture at its actual resolution.
Once the zoom is set, it will be stored in memory for the
current input signal.
1
Press the MENU button.
The MENU OSD appears.
MENU
iKi PHASE
am PITCH
OCENTER
gSZOOM
B COLOR
B LANGUAGE
aOPTION
2
Press the buttons to select ZOOM, and press the
MENU button again.
The ZOOM OSD appears.
*(3
MENU
ZOOM
4
For horizontal adjustment select H using the
buttons and adjust the position using the +/-
buttons.
+ . . . to move the picture right
- . . . to move the picture left
CENTER
3
3b
r
1
26
a
For vertical adjustment select V using the
buttons and adjust the position using the +/-
buttons.
• f . . . to move the picture up
- . . . to move the picture down
3
3b
3
Press the ^ button to select REAL MODE, and press
the MENU button again.
The MENU OSD appears.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To display the picture on the screen in full
Press the 0 button in step 3 to select FULL MODE.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To
turn off the test pattern, click I
end
] on the screen.
12